PCE-CL 10 Cable detector
it detects cables for lines with or without voltage / to check circuits and lines / location of short circuits and ground (in ground, concrete and brick walls)

With the  PCE-CL 10 cable detector you can detect voltage lines up to 400 V in circuits and free-voltage lines. The  PCE-CL 10 cable detector can locate cables, lines, circuits, short circuits, ground as well as test protective tubing and coaxial cables. To perform these functions, it is not necessary to disconnect the power source or to disconnect the power to the cable being tested. The location can be carried out in ground, concrete walls and brick walls by the PCE-CL 10 cable detector. Cable detection system is composed of a signal generator for active lines and a transmitter for cables without current such as a receiver. The signal generator feeds high frequency electro-magnetic signals through the lines being tested. These signals are converted at the end of the cable, into acoustic or optical signals by the receiver. The intensity of the signal is the standard used for locating the line. In the signal generator both the signal power and the searching channel can be regulated. The PCE-CL 10 cable detector can simultaneously work with diverse transmitters without any interference between them. At the following link you will find an overview of all cable detectors available at PCE-Group.  

View / print user’s manual of the PCE-CL 10 cable detector

 - Lines can be detected in floors, ceilings and walls.

 - Detection of interruptions in cables, switches and fuse

 - Detection of short circuits

- Detection of ground connection in triple phase mains power

 - Follow protective tubing in water and heating

 - Lines distribution

Thanks to the backlight display it is possible to easy read data on the display even in poor light conditions

Functions of the components

Technical specifications

General observaions

Operating temperature / humidity

0 ... 40 ºC / max. 80% H.r.

Storing temperature / humidity

-20 ... + 60 ºC / max. 80% H.r.

Receiver

Auto shut-off

approx. 5 min.

Absorbed power

max. 40 mA

Display

LCD with bar graph

Battery

9 V battery

Dimensions

192 x 61 x 37 mm

Weight

approx. 180 g

Signal generator

Maximum voltage

400 V AC (0-60 Hz
400 V DC)

Transmitting frequency

125 kHz

Display

LCD

Auto shut-off

approx. 1 hour

Absorbed power

max. 18 mA

Battery

9 V battery

Fuses

Flink, 0,5 A / 500 V, 6,3 x 32 mm

Overvoltage category

CAT III / 300 V

Dimensions

130 x 69 x 32 mm

Weight

130 g

PCE-CL 10 cable detector looking
for the correct fuse

The accessories of the PCE-CL 10 cable detector included in the delivery can be kept in its carrying case.

Delivery contents
1 x PCE-CL 10 cable detector composed by a carrying case and a signal generator, 1 x receiver, 2 x batteries, 2 testing cables, 2 x alligator clips, 2 x clips and user’s manual.

Here you will find all the measuring instruments available at PCE Instruments.

This page in German in Italian in Spanish in Croatian in French

Below you will find an overview of the different product groups of measuring instruments