pellets moisture tester pce-pel-20 is designed in collaboration with biomass
power plant operators. Since the heating value of pellets depends strongly its
moisture the pellets moisture tester can be applied in order to reach as high
efficiency as possible. The pellets moisture tester performs a moisture
detection due to its resistance. It means that the pellets moisture meter
collects the resistance of the test sample in order to gain information about
its moisture due to its characteristic curve.
Therefore it is of great
importance to adjust the appropriate characteristic curve and temperature of the
pellets moisture meter. The pellets moisture tester is applicable for
comparative measurements of pellets that are made of either sawdust, wood chips,
straw, hay, scraps of pellets, shells of sunflowers, buckwheat, corn, soya etc.
Therefore simply plunge the 1000 mm long sensor-probe into the pile of pellet
and the measuring data will be collected after its stabilization. The pellets
moisture tester only measures at the tip of its sensor-probe. It is advised to
perform several measurements at different points in order to achieve an adequate
overview of the water content of the pile. Thus the pellets moisture tester
pce-pel-20 helps providing quick, easy and low cost information about pellets
If there are any questions about this pellets moisture tester, please have a look at the
technical specification below or call: UK customers +44(0) 23 809 870 30 / US customers +1-410-387-7703. Our technicians and engineers will gladly advise you in all pellets
moisture testers and all products in the field of measuring
and control and scales.